Wall Spouts

A wall spout is the plain outlet that water leaves by, mounted on the wall face and fed from a mixer or a stop valve somewhere else. Most have no handle and no cartridge of their own, which is the whole idea: the control happens at the mixer, and the spout is simply where the water comes out. In an Indian bathroom this is the fitting over the bathtub, or the bucket filler beside the shower area. Every spout here is cast from solid lead-free brass ingot and plated in three layers, copper, then 10-micron nickel, then 0.3-micron chromium, with a food-grade foam-flow aerator at the tip that softens the stream and saves around 20 per cent of the water a plain outlet uses. The range includes one two-way spout that carries its own diverter. Prices run from around Rs 1,600 to Rs 1,770.

How to choose a wall spout

  • Decide whether you need a diverter. A plain spout is one outlet. A two-way spout carries a diverter in the body, so a single wall outlet can feed two destinations. If your mixer already diverts, you do not need a second one here.
  • Check the projection against the tub or bucket. The spout has to reach far enough that water lands inside, not down the outside of the bath or the wall.
  • Set the height for what you fill. If the spout doubles as a bucket filler, leave enough clearance underneath for a full-size bucket to stand upright.
  • Match the finish to the mixer. The spout sits directly below the mixer and any mismatch in chrome tone is obvious at close range.

Aerators, pressure and hard water

The aerator at the tip mixes air into the stream. It softens the flow, cuts splash noise and reduces consumption, and it is also the part that scales up first. When a spout seems to have lost pressure, the aerator has almost always blocked rather than anything failing upstream: unscrew it, soak it in warm water, brush it and refit. On a gravity-fed overhead tank the aerated stream feels fuller with more head above the fitting, but there is no minimum pressure for the spout itself.

Common questions

Does a wall spout have its own tap? Usually not. A plain wall spout is an open outlet controlled by a mixer or stop valve elsewhere. The two-way version in this range has a diverter, but still no on-off control of its own.

Can I use a wall spout as a bucket filler? Yes, and it is a common use in Indian bathrooms. Mount it high enough for a full bucket to fit underneath.

Why is water running down the wall instead of into the bath? Either the projection is too short for the tub, or the aerator has scaled and the stream has lost its shape. Check the aerator first.