Wall Mounted Basin Mixers

A wall mounted basin mixer takes hot and cold through the wall and puts only the spout and the lever out over the basin, leaving the counter and the basin rim completely clear. That is its real advantage over a deck-mounted mixer: nothing to clean around, and no drilled hole in a countertop basin. The range here is solid brass bodied, in chrome, gold, rose gold and graphite, from around ₹4,960 for a single lever sink mixer supplied as a complete set up to around ₹18,500 at the top of the chrome range.

How to choose a wall mounted basin mixer

  • Establish what is in the box before ordering. A wall mixer has two parts: a concealed body that goes inside the wall and the exposed spout and lever that you see. Some items here are listed as complete sets. The two parts must be matched, so confirm which you are buying rather than assuming.
  • Decide before the wall is tiled. The concealed body must be set into the masonry and the pipework brought to it before the wall closes up. Choosing a wall mixer after tiling means breaking tiles, which is why this decision belongs at the plumbing-rough stage, not at the fit-out stage.
  • Check spout projection against your basin. The spout has to reach past the front edge of the basin and deliver water near the centre of the bowl. A shallow projection over a wide countertop basin sends water down the back wall of the bowl and splashes.
  • Match the finish across the whole basin. Gold, rose gold and graphite look wrong beside a chrome waste coupling or a chrome bottle trap. If you choose a coloured finish here, plan the waste coupling and the flush plate in the same finish at the same time.
  • Consider your water pressure. On a gravity-fed overhead tank a long wall spout gives a softer, gentler stream than the same fitting on a pressure pump. If your building runs on tank head alone, expect a calmer flow rather than a forceful one.

Finishes and what they ask of you

Chrome is the default across this range and the easiest to live with: it cleans back to new with a soft cloth and matches almost every other CP fitting in an Indian bathroom. Gold and rose gold read warmer and are typically chosen for a guest bathroom or a powder room where the whole scheme is planned together. Graphite is the darkest option and hides water spotting best in hard-water areas.

Whichever finish you choose, hard water is the maintenance issue rather than wear. Wipe the spout dry after use, and keep acidic limescale removers away from the plated surfaces. Where scale builds inside the spout outlet, the aerator is normally the part to clean rather than the mixer body.

Common questions

What is the difference between a wall mounted and a deck mounted basin mixer? A deck mounted mixer sits on the basin or the counter and needs a tap hole drilled in it. A wall mounted mixer comes out of the wall above the basin, so the basin can be a hole-free countertop bowl and there is nothing on the counter to clean around.

Can I fit a wall mounted basin mixer in an existing bathroom? Only if you are prepared to break into the wall. The concealed body sits behind the tiles and needs plumbing brought to it, so retrofitting means cutting tile and re-plastering. In a bathroom you do not want to disturb, a deck mounted mixer or a pillar cock is the practical choice.

Is a brass body worth the difference in price? Yes for a fitting that is partly buried in a wall. The concealed portion cannot be inspected or easily replaced once tiled over, so the corrosion resistance and the thread strength of solid brass are exactly where the money should go.